Step 1: Building the wing jigs (and wing templates)

ch19_02

2016-01-24: Spent quite some time to sand down the templates to make them as smooth as possible.

ch19_03
2016-01-27: Preparations for the wing jigs. Cut out the planforms from a sheet of 12mm plywood. Glued the paper templates to the corresponding pieces.

ch19_04
2016-01-31: Using my bandsaw to cut the jigs, along with my jigsaw for the tighter curves.

ch19_05
2016-01-31: I used wood screws to fasten the jigs to my work table before I drilled and floxed the links to the jigs. I drilled the 1/4″ holes for the bolts through my table and inserted the bolt all the way down through the table.

Leave a Reply

Your email address will not be published. Required fields are marked *