Step 2: Fabrication of Pitch and Roll Parts

2021-02-22: I cut all the tubes according to the plans.

One thing I really dislike is when it says “cut according to plans, leaving CS-121 a little long for later trimming to fit”. How long is “a little long”? I ended up adding 1 inch to the length. We’ll see if that is enough.

Update on this after step 4: I ended up cutting CS-121 shorter than plans. My CS-121 ended up beeing 34″ long. YMMV.

Then I layed all the tubing out on the floor to get a look on how it will be:

I have purchased the stick grips from Infinity Aerospace: