2014-01-01: I made the static-port as per plans. I will make one port on each side and connect them together later. Started by cutting a 4″ piece of 1/4″ soft aluminum tubing. I pinched the end of the tubing.
2014-01-01: Then I bent the tube like this.
2014-01-01: Drilled a 1/4″ hole in the inside skin, pointing downward. This picture is taken from the top and down.
2014-01-01: Filled the hole with wet micro and stuck the tube in the hole and set to cure. Did the same procedure on the other side of the fuselage.
Started: 2014-01-01
Ended: N/A