Step 1: Pivot Mounts

2021-02-21: In this step I will fabricate the 4 pivot mounts out of plywood.

I am replacing the phenolic bearings with IGUS-EFOI 10R bearings.

In this picture I have mounted the left bearings on the wrong side of the pivot mounts. I forgot to reverse the mounts.

Finally I made the required dimples in the CS-123 bronze bearings.

I was originally going for the Bearing Assembly from the Cozy Girrrls here, but they where out of stock. After reading some articles I found that these simple bronze bearings works all fine. They are a lot cheaper!